Aries Marine’s certified inspectors are available to support your requirements in in-service tank inspection, in-service inspection of pressure vessels, piping in-service inspection.

  •  In-Service & Out-of-Service Inspections (Internal & External).
  •  Consultancy for Maintenance & Repair works.
  •  Fitness for service evaluation .
  •  Failure analysis & investigation.
  •  Integrity Analysis, Remaining life Assessment and Corrosion Rate Evaluation.
  •  Damage Mechanism Analysis (API 571).
  •  New tank fabrication inspection/ Reconstruction
  •  Tank settlement evaluation (Foundation, Shell, Bottom & Edge Settlement).
  •  Dimensional survey (Roundness, Plumbness, Peaking & Banding measurements).
  •  Coating/ Painting/ Lining inspection.
  •  NDT- MFL (3D floor map), Vacuum box, UT, MT, PT, AUT (Scorpion) B Scan, Hand Scan, RT, PAUT, SRUT etc..
  •  Mechanical/ Metallurgical tests and PWHT.
  •  Corrosion Monitoring.
  •  Thickness Monitoring Service(TML’s).
  •  Hydro test & Pneumatic Test .
  •  Tank Calibration .

  •  Detailed Internal and external inspection (during On-steam/ Off stream and Turnaround)
  •  Consultancy for Maintenance & Repair works.
  •  Fitness for service evaluation .
  •  Failure analysis & investigation.
  •  Integrity Analysis, Remaining life Assessment and Corrosion Rate Evaluation
  •  Damage Mechanism Analysis (API 571)
  •  On-site fabrication / erection/ installation inspection
  •  Vendor Surveillance and Audit Services
  •  NDT – UT, PAUT, MT,WFMPI, PT, LT, RT, LRUT, SRUT, IRIS
  •  Corrosion Monitoring
  •  Corrosion Monitoring
  •  Thickness Monitoring Service(TML’s)
  •  Rerating
  •  Mechanical/ Metallurgical tests and PWHT
  •  Hydro test & Pneumatic Test

  •  Turnaround/ On-stream Inspections
  •  External Visual Inspection of Above Ground Pipelines
  •  Consultancy for Maintenance & Repair works
  •  Fitness for service evaluation
  •  Failure analysis & investigation
  •  Integrity Analysis, Remaining life Assessment and Corrosion Rate Evaluation
  •  Damage Mechanism Analysis (API 571)
  •  NDT – UT, PAUT, MT, PT, LT, RT, MFL, LRUT, SRUT, IRIS
  •  Corrosion Monitoring
  •  Thickness Monitoring Service(TML’s)
  •  Mechanical/ Metallurgical tests and PWHT
  •  Hydro test & Pneumatic Test
  •  Volumetric Calibration